Show Ip Rip Database - Dell C9000 Series Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Example
Dell(conf-router_rip)#show config
!
router rip
Dell(conf-router_rip)#

show ip rip database

Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
C9000 Series
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address
mask
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
(OPTIONAL) Specify an IP address in dotted decimal format to
view RIP information on that network only. If you enter an IP
address, also enter a mask for that IP address.
(OPTIONAL) Specify a mask, in /network format, for the IP
address.
Routing Information Protocol (RIP) 1907