Seq (Extended Mac Acls) - Dell 8 Command Reference Manual

Dell converged enhanced ethernet command reference
Hide thumbs Also See for 8:
Table of Contents

Advertisement

10

seq (extended MAC ACLs)

seq (extended MAC ACLs)
Inserts a rule anywhere in the MAC ACL.
Synopsis
seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL}
[EtherType |arp |fcoe | ipv4] [count]
no seq value
Operands
value
permit or deny
Defaults
By default, no MAC ACLs are configured.
Command
Feature Access Control List Configuration mode
Modes
Description
Use this command to insert a rule anywhere in the MAC ACL; it configures rules to match and
permits or drops traffic based on the source and destination MAC addresses, and the protocol type.
You can also enable counters for a specific rule. There are 255 ACL counters supported per port
group. Use the no seq value command to remove a rule from the MAC ACL.
Usage
The first set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the source MAC
Guidelines
address. The second set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the
destination MAC address.
152
Specifies the sequence number for the rule. The range of valid values is
0-65535.
Specifies rules to permit or deny traffic.
any
Specifies any source MAC address.
host MAC_ACL
Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
MAC_ACL
Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
any
Specifies any destination MAC address.
host MAC_ACL
Specifies the destination host address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
MAC_ACL
Specifies the destination host address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
Ethertype
Specifies the protocol number for which to set the permit or deny conditions.
The range of valid values is 1536-65535.
arp
Specifies to permit or deny the Address Resolution Protocol (0x0806).
fcoe
Specifies to permit or deny the Fibre Channel over Ethernet Protocol
(0x8906).
ipv4
Specifies to permit or deny the IPv4 protocol (0x0800).
count
Enables the counting of the packets matching the rule.
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01

Advertisement

Table of Contents
loading

Table of Contents