Netscreen-Remote; Network Address Translation (Nat); Point-To-Point Protocol Over Ethernet (Pppoe); Switching - Dell PowerConnect J-8208 Release Note

Junos 10.3 OS Release Notes
28
NOTE: For J-SRX devices, to use the Chassis View, version 9 or later of
Adobe Flash Player must be installed. Chassis View is displayed by default
on the Dashboard page. You can enable or disable the Chassis View using
options in the Dashboard Preference dialog box.

NetScreen-Remote

On J-SRX Series devices, NetScreen-Remote is not supported in Junos OS Release
10.3.

Network Address Translation (NAT)

NAT rule capacity change—To support the use of large-scale NAT (LSN) at the edge
of the carrier network, the device-wide NAT rule capacity has been changed.
The number of destination and static NAT rules has been incremented as shown in
Table 1 on page 28. The limitation on the number of destination-rule-set and
static-rule-set has been increased.
Table 1 on page 28 provides the requirements per device to increase the configuration
limitation as well as scale the capacity for each device.
Table 1: Number of Rules on J-SRX Series Devices
NAT Rule Type
Source NAT rule
Destination NAT rule
Static NAT rule
The restriction on the number of rules per rule set has been increased so that there is
only a device-wide limitation on how many rules a device can support. This restriction
is provided to help you better plan and configure the NAT rules for the device.

Point-to-Point Protocol over Ethernet (PPPoE)

On J-SRX240 devices in a chassis cluster, the
underlying interface for Point-to-Point Protocol over Ethernet (PPPoE).

Switching

On J-SRX100, J-SRX210, and J-SRX240 devices, CoA is not supported with 802.1x.
On J-SRX100, J-SRX210, and J-SRX240 devices, on the routed VLAN interface, the
following features are not supported:
IPv6 (family inet6)
ISIS (family ISO)
Class-of-service
J-SRX100 J-SRX210
512 512
512 512
512 512
interface cannot be used as the
reth
J-SRX240
1024
1024
1024