Timer I/O Control Registers (Tior) - Renesas H8S/2319 series Hardware Manual

9.2.3

Timer I/O Control Registers (TIOR)

Channel 0: TIOR0H
Channel 1: TIOR1
Channel 2: TIOR2
Channel 3: TIOR3H
Channel 4: TIOR4
Channel 5: TIOR5
Bit : 7
IOB3
Initial value : 0
R/W : R/W
Channel 0: TIOR0L
Channel 3: TIOR3L
Bit : 7
IOD3
Initial value : 0
R/W
R/W :
Note: When TGRC or TGRD is designated for buffer operation, this setting is invalid and the
register operates as a buffer register.
The TIOR registers are 8-bit registers that control the TGR registers. The TPU has eight TIOR
registers, two each for channels 0 and 3, and one each for channels 1, 2, 4, and 5. The TIOR
registers are initialized to H'00 by a reset and in hardware standby mode.
Care is required since TIOR is affected by the TMDR setting. The initial output specified by
TIOR is valid when the counter is stopped (the CST bit in TSTR is cleared to 0). Note also that, in
PWM mode 2, the output at the point at which the counter is cleared to 0 is specified.
6 5
IOB2 IOB1 IOB0
0 0
R/W R/W
6 5
IOD2 IOD1 IOD0
0 0
R/W R/W
4 3
IOA3 IOA2
0 0
R/W R/W R/W
4 3
IOC3 IOC2
0 0
R/W R/W R/W
Rev. 5.00, 12/03, page 311 of 1088
2 1 0
IOA1 IOA0
0 0 0
R/W R/W
2 1 0
IOC1 IOC0
0 0 0
R/W R/W