Table of Contents
Advertisement
Host
Communications Protocol
After adjustment of the bit rate, the protocol for communications between the host and the boot
program is as shown below.
(1) One-byte commands and one-byte responses
These commands and responses are comprised of a single byte. These are consists of the
inquiries and the ACK for successful completion.
(2) n-byte commands or n-byte responses
These commands and responses are comprised of n bytes of data. These are selections and
responses to inquiries.
The amount of programming data is not included under this heading because it is determined
in another command.
(3) Error response
The error response is a response to inquiries. It consists of an error response and an error code
and comes two bytes.
(4) Programming of n bytes
The size is not specified in commands. The size of n is indicated in response to the
programming unit inquiry.
(5) Memory read response
This response consists of four bytes of data.
H'00 (30 times maximum)
H'00 (Completion of Adjustment)
H'E6 (Response to Boot)
H'FF (Error)
Figure 17-83 Bit-Rate-Adjustment Sequence
H'55
Rev. 5.00, 12/03, page 733 of 1088
Boot Program
Measuring the
1-Bit Length
Advertisement
Table of Contents
