20.5
Usage Note
Although both the F-ZTAT and mask ROM versions fully meet the electrical specifications listed
in this manual, there may be differences in the actual values of the electrical characteristics,
operating margins, noise margins, and so forth, due to differences in the fabrication process, the
on-chip ROM, and the layout patterns.
If the F-ZTAT version is used to carry out system evaluation and testing, therefore, when
switching to the mask ROM version the same evaluation and testing procedures should also be
conducted on this version.
External capacitor
to stabilize the
power supply
0.1 µF
Do not connect the V
CC
Doing so could permanently damage the LSI. (Connect
the V
power-supply to the V
CC
Use a multilayer ceramic capacitor (0.1 µF), and place
it near the pins.
Figure 20.24 V
Capacitor Connection Method
CL
V
CL
V
SS
power-supply to the V
CL
pin, in the usual way.)
CC
Rev. 5.00, 12/03, page 845 of 1088
pin.