Table of Contents
Advertisement
Do not perform additional programming. Erase the memory before reprogramming: In on-
board programming, perform only one programming operation on a 128-byte programming unit
block. In programmer mode, too, perform only one programming operation on a 128-byte
programming unit block. Programming should be carried out with the entire programming unit
block erased.
Before programming, check that the chip is correctly mounted in the PROM programmer:
Overcurrent damage to the device can result if the index marks on the PROM programmer socket,
socket adapter, and chip are not correctly aligned.
Do not touch the socket adapter or chip during programming: Touching either of these can
cause contact faults and write errors.
Rev. 5.00, 12/03, page 663 of 1088
Advertisement
Table of Contents
