Renesas H8S/2319 series Hardware Manual page 357

The TSR registers are 8-bit registers that indicate the status of each channel. The TPU has six TSR
registers, one for each channel. The TSR registers are initialized to H'C0 by a reset and in
hardware standby mode.
Bit 7—Count Direction Flag (TCFD): Status flag that shows the direction in which TCNT
counts in channels 1, 2, 4, and 5.
In channels 0 and 3, bit 7 is reserved. It is always read as 1 and cannot be modified.
Bit 7
TCFD Description
0 TCNT counts down
1 TCNT counts up
Bit 6—Reserved: This bit cannot be modified and is always read as 1.
Bit 5—Underflow Flag (TCFU): Status flag that indicates that TCNT underflow has occurred
when channels 1, 2, 4, and 5 are set to phase counting mode.
In channels 0 and 3, bit 5 is reserved. It is always read as 0 and cannot be modified.
Bit 5
TCFU Description
0 [Clearing condition]
When 0 is written to TCFU after reading TCFU = 1
1 [Setting condition]
When the TCNT value underflows (changes from H'0000 to H'FFFF)
Bit 4—Overflow Flag (TCFV): Status flag that indicates that TCNT overflow has occurred.
Bit 4
TCFV Description
0 [Clearing condition]
When 0 is written to TCFV after reading TCFV = 1
1 [Setting condition]
When the TCNT value overflows (changes from H'FFFF to H'0000 )
Rev. 5.00, 12/03, page 327 of 1088
(Initial value)
(Initial value)
(Initial value)