Dell S6100 Configuration Manual page 1505

access-list-name
ipv6 access-list-
name
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.10.2
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information The following example specifies the group named harig as a version 3 user requiring both authentication and
encryption and read access limited to the read named rview.
Example
Dell# conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related Commands
•
•
(Optional) Enter both an IPv4 and IPv6 access list name.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for the access parameter.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: The number of configurable groups is limited to 16
groups.
show snmp group — displays the group name, security model, view status, and storage type of each group.
show running-config — displays the SNMP running configuration.
Simple Network Management Protocol (SNMP) and Syslog 1505