Ip Multicast-Routing - Dell Z9500 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.7.0
7.8.1.0
7.6.1.0
Usage This feature allows you to limit the number of multicast entries on the system. This
Information number is the total of all the multicast entries on all line cards in the system. On
each line card, the multicast module only installs the maximum number of entries,
depending on the configured CAM profile.
To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate
hardware limit that exists per port-pipe. This hardware space limitation can
supersede any software-configured limit. The opposite is also true, the CAM
partition might not be exhausted at the time the system-wide route limit set by the
ip multicast-limit command is reached.
Related show ip igmp groups
Commands

ip multicast-routing

Enable IP multicast forwarding.
Z9500
Syntax
ip multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ip multicast-routing [vrf
vrf-name] command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
Multicast
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series.
— shows the IGMP groups.
1173