Dell S6100 Configuration Manual page 1508

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.4.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information
To configure the router to send SNMP notifications, enter at least one snmp-server host command. If you
enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-
server host command, no notifications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command for each host. You can specify
multiple notification types in the command for each host.
When multiple snmp-server host commands are given for the same host and type of notification (trap or
inform), each succeeding command overwrites the previous command. Only the last snmp-server host
command will be in effect. For example, if you enter an snmp-server host inform command for a host and
then enter another snmp-server host inform command for the same host, the second command replaces
the first command.
The snmp-server host command is used with the snmp-server enable command. Use the snmp-
server enable command to specify which SNMP notifications are sent globally. For a host to receive most
notifications, at least one snmp-server enable command and the snmp-server host command for that
host must be enabled.
Configuring Informs
To send an inform, use the following steps:
1
2
3
4
5
Related Commands
•
•
1508 Simple Network Management Protocol (SNMP) and Syslog
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP notification types. Introduced on the S-Series.
Introduced on the C-Series.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined using the snmp-server
community command prior to using this command, the default form of the snmp-server
community command automatically is configured with the community-name the same as specified in
the snmp-server host command.
Configure a remote engine ID.
Configure a remote user.
Configure a group for this user with access rights.
Enable traps.
Configure a host to receive informs.
snmp-server enable traps — enables SNMP traps.
snmp-server community — configures a new community SNMPv1 or SNMPv2c.