container with it so that the waste toner does not
spill out.
Removing the Drum Unit
■ Preparation
1. Open the right cover.
2. Open the front cover.
3. Remove the waste toner
Waste Toner Container" on page 150
■ Procedure
1. Remove the screw securing the developing
assembly pressure lever. (Models for some
destinations do not have this screw.)
2. Turn the lever in the direction of the arrow to release
the lock of the drum unit.
1x
container."Removing the
3. While raising the lever under the handle of the drum
unit, slowly pull out the drum unit to the position
shown below.
4. Pull out the drum unit slightly upward.
CAUTION:
Do not touch the drum surface during the work.
Removing the Developing
Assembly
■ Preparation
1. Open the right cover.
2. Open the front cover.
3. Remove the waste toner
Waste Toner Container" on page 150
4. Remove the drum
page 151
5. Remove the toner supply
Toner Supply Cover" on page 134
151
4. Disassembly/Assembly
container."Removing the
unit."Removing the Drum Unit" on
cover."Removing the