Points to Note When Mounting the Flange
There is hardly a gap between the flange and the inner side of the drum,
causing the flange to get stuck if pushed at an angle.
When mounting the flange, push it in a parallel direction to the drum
without applying excessive force.
8.9.8 Developing Assembly
8.9.8.1 Removing the Developing Assembly
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Open the manual feed tray cover; then, remove the six mounting
screws [1], and detach the developing assembly stay [2].
[1]
2) Disconnect the two connectors [3], and slide out the developing
assembly [4] to the front.
[6]
F-8-92
0007-2360
[1]
[2]
F-8-93
[4]
[3]
8.9.8.2 Removing the Hopper
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Remove the developing assembly from the machine.
2) Remove the four mounting screws [1], and disconnect the connector
[2]; then, detach the hopper [3].
[1]
8.9.9 Developing Cylinder
8.9.9.1 Removing the Developing Cylinder
iR105i/iR105+ / iR9070 / iR85+ / iR8070
Chapter 8
[3]
F-8-94
0007-2362
[3]
[1]
[2]
F-8-95
[1]
F-8-96
0007-2383
8-47