Table of Contents
Advertisement
match interface
To match routes whose next hop is on the interface specified, configure a filter.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface
Defaults
Not configured.
Command
ROUTE-MAP
Modes
Command
Version
History
8.3.16.0
Related
match ip address
Commands
match ip next-hop
match ip route-source
routers.
match metric
match route-type
match tag
match ip address
To match routes based on IP addresses specified in an access list, configure a filter.
Syntax
match ip address prefix-list-name
202
Enter the following keywords and slot/port or number
information:
•
For the Loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Introduced on the MXL 10/40GbE Switch IO Module.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Access Control Lists (ACL)
Advertisement
Table of Contents
