Deny (For Extended Ip Acls) - Dell MXL 10GbE Reference Manual

deny (for Extended IP ACLs)

Configure a filter that drops IP packets meeting the filter criteria.
Syntax
deny {ip | ip-protocol-number} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [count
[byte]] [dscp value] [order] [monitor] [fragments] [log
[interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
source
mask
any
host ip-address
destination
count
byte
order
monitor
fragments
log
Access Control Lists (ACL)
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny {ip | ip-protocol-number} {source mask | any |
host ip-address} {destination mask | any | host ip-address}
command.
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Enter the keyword fragments to use ACLs to control packet
fragments.
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
213