Common Mac Access List Commands - Dell MXL 10GbE Reference Manual

monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
deny
Commands
permit

Common MAC Access List Commands

The following commands are available within both MAC ACL modes (Standard and Extended) and do not
have mode-specific options. These commands allow you to clear, display, and assign MAC ACL
configurations. The MAC ACL can be applied on Physical, Port-channel and VLAN interfaces. As per the
stipulated rules in the ACL, the traffic on the Interface/VLAN members or Port-channel members will be
permitted or denied.
The MXL 10/40GbE Switch IO Module platform supports both Ingress and Egress MAC ACLs.
clear counters mac access-group
Clear counters for all or a specific MAC ACL.
Syntax
clear counters mac access-group [mac-list-name]
Parameters
mac-list-name
Command EXEC Privilege
Modes
Command
Version 8.3.16.1
History
mac access-group
Apply a MAC ACL to traffic entering or exiting an interface. Enter into the Interface mode and apply the
MAC ACL in the following manner.
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
180
— Configures a filter to drop packets.
— Configures a filter to forward packets.
(OPTIONAL) Enter the name of a configured MAC access list.
Introduced on the MXL 10/40GbE Switch IO Module.
Access Control Lists (ACL)