Extended Mac Acl Commands - Dell MXL 10GbE Reference Manual

permit

Extended MAC ACL Commands

When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit. The following commands configure Extended MAC ACLs.
The MXL 10/40GbE Switch IO Module platform supports both Ingress and Egress MAC ACLs.
deny
To drop packets that match the filter criteria, configure a filter.
Syntax
deny {any | host mac-address | mac-source-address mac-source-
address-mask} {any | host mac-address | mac-destination-address
mac-destination-address-mask} [ethertype-operator] [count
[byte]]
To remove this filter, you have two choices:
•
•
Parameters
any
host mac-
address
mac-source-
address
mac-source-
address-mask
mac-
destination-
address
190
— configures a filter to forward packets.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny {any | host mac-address | mac-source-address
mac-source-address-mask} {any | host mac-address | mac-
destination-address mac-destination-address-mask} command.
Enter the keyword any to drop all packets.
Enter the keyword host and then enter a MAC address to
drop packets with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
Access Control Lists (ACL)