Tunnel Source - Dell C9000 Series Reference Manual

Configuration of IPv6 commands over decapsulate-any tunnel causes an error.

tunnel source

Set a source address for the tunnel.
C9000 Series
Syntax
tunnel source {ip-address | ipv6–address | interface-type-number |
anylocal}
To delete the current tunnel source address, use the no tunnel source command.
Parameters
ip-address
ipv6–address
interface-type-
number
anylocal
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
Version
9.9(0.0)
9.7(0.0)
9.4(0.0)
9.2(0.0)
Usage Information Added an optional keyword "anylocal" to the tunnel source command. The anylocal
argument can be used in place of the ip address or interface, but only with the
Enter the source IPv4 address in A.B.C.D format.
Enter the source IPv6 address in X:X:X:X::X format.
• For a port channel interface, enter the keywords port-
channel then a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Enter the anylocal command to allow the multipoint receive-
only tunnel to decapsulate tunnel packets destined to any local
ip address.
Description
Introduced on the C9010.
Introduced on the S6000-ON.
Added the tunnel source anylocal command.
Introduced on the MXL 10/40GbE Switch IO Module.
Tunneling Commands 2189