Service-Class Dot1P-Mapping - Dell Z9500 Command Reference Manual

POLICY-OUT mode supersedes the service-class bandwidth-percentage
command.

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.
Z9500
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
dot1p0 value ...
dot1p7 value
Defaults For each dot1p Priority, the default CoS queue value is:
•
•
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.16.0
Usage To apply dot1p-queue-mapping, use the service-class dynamic dot1p
Information
command.
Related show qos dot1p-queue-mapping
Commands on the switch.
Quality of Service (QoS)
Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
dot1p Priority: 0 1 2 3 4 5 6 7
CoS Queue: 2 0 1 3 4 5 6 7
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
— displays the dot1p priority to queue mapping
1475