Service-Class Dot1P-Mapping - Dell S6000 Reference Manual

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.
S6000
Syntax
service-class dot1p-mapping {dot1p0 queue | dot1p1 queue |
dot1p2 queue | dot1p3 queue | dot1p4 queue| dot1p5 queue |
dot1p6 queue | dot1p7 queue}
Parameters
queue
Defaults For each dot1p Priority, the default CoS queue value is:
•
•
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage To apply dot1p-queue-mapping, use the service-class dynamic dot1p
Information
command.
Related show qos dot1p-queue-mapping
Commands on the switch.
show qos dot1p-queue-mapping
Displays the dot1p priority to queue mapping on the switch.
S6000
Syntax
show qos dot1p-queue-mapping
Defaults
•
•
1108
Enter a value from 0 to 7.
Dot1p Priority : 0 1 2 3 4 5 6 7
Queue : 2 0 1 3 4 5 6 7
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
dot1p Priority: 0 1 2 3 4 5 6 7
Queue: 2 0 1 3 4 5 6 7
— displays the dot1p priority to queue mapping
Quality of Service (QoS)