Trigger[:Sequence]:Slope <Character_Data - Agilent Technologies N1911A Programming Manual

TRIGger[:SEQuence]:SLOPe <character_data>
This command specifies whether a trigger event is recognized on the rising
or falling edge of a signal.
This command is also applicable for external triggered average measurement when used
N O T E
with 8480, N8480, E4410, E9300 or E9320 sensor (Average mode only).
Syntax
Parameters
N1911A/1912A P-Series Power Meters Programming Guide
TRIG :SEQ
Item Description/Default
character_data How a trigger event is recognized:
• POSitive: a trigger event is recognized on
the rising edge of a signal.
• NEGative: a trigger event is recognized on
the falling edge of a signal.
Space
:SLOP
TRIGger Subsystem
character_data
?
Range of Values
POSitive
NEGative
14
675