[Sense[1]]|Sense2:Trace Commands - Agilent Technologies N1911A Programming Manual

10 SENSe Subsystem

[SENSe[1]]|SENSe2:TRACe Commands

These commands are used to set:
• The upper and lower limits for the trace display
• The delay between the delayed trigger point and the start of the trace
• The duration of the trace
•
These commands can only be used with P-Series and E9320 sensors. The E9320 sensor
N O T E
must be set to NORMal mode.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:TRACe:LIMit:LOWer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:LIMit:UPPer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:OFFSet:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data>
444
The trace units.
N1911A/1912A P-Series Power Meters Programming Guide