Agilent Technologies N1911A Programming Manual page 421

Example
CORR:CSET1 'PW1'
Reset Condition
On reset the selected table is not affected.
Query
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:[SELect]?
The name of the selected table is returned as a quoted string. If no table
is selected an empty string is returned.
Query Example
CORR:CSET1?
Error Messages
• If <string> is not valid, error –224, "Illegal parameter value" occurs.
• If a table called <string> does not exist, error –256, "File name not
•
N1911A/1912A P-Series Power Meters Programming Guide
found" occurs.
When a sensor calibration table is selected, the power meter verifies
that the number of calibration points defined is one more than the
number of frequency points defined. When a frequency dependent
This command enters the name of the
sensor calibration table which is to be
used on Channel A.
This command queries the sensor
calibration table currently used for
Channel A.
SENSe Subsystem 10
393