Agilent Technologies N1911A Programming Manual page 428

10 SENSe Subsystem
Reset Condition
On reset, the duty cycle is set to 1 % (DEF).
Query
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut]
[:MAGNitude]? [MIN|MAX]
The query returns the current setting of the duty cycle or the values
associated with MIN and MAX.
Query Example
CORR:GAIN3?
Error Messages
• If a duty cycle value is entered using
• If this command is used when an E4412A/E4413A power sensor is
• If this command is used when a E9320 Series power sensor is set to
• If this command is used when a P- Series power sensor is connected,
400
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, "Settings
Conflict" occurs. However, the duty cycle value is set but the
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe command is
not automatically set ON.
connected, the error –310, "System error;Dty Cyc may impair accuracy
with ECP sensor" occurs. If you are using a dual channel power meter
the error message specifies the channel.
NORMal mode, the error –221, "Settings Conflict" occurs.
the error –241, "Hardware missing" occurs.
This command queries the current setting
of the duty cycle for Channel A.
N1911A/1912A P-Series Power Meters Programming Guide