Agilent Technologies N1911A Programming Manual page 203

Example
CALC1:LIM:CLE:AUTO 1
Reset Condition
On reset, both windows and their measurements are set to ON.
Query
CALCulate[1]|2|3|4:LIMit:CLEar:AUTO?
The query command enters a 1 or 0 into the output buffer indicating
whether limit failures are cleared automatically when a new measurement
is initiated on the specified window section.
• 1 is entered into the output buffer when limit failures are cleared
• 0 is entered into the output buffer when limit failures are not cleared
In the case where limit failures are cleared once, when a query occurs a 1
is entered into the output buffer if no measurement is initiated. If a
measurement is initiated then 0 is entered.
Query Example
CALC1:LIM:CLE:AUTO?
N1911A/1912A P-Series Power Meters Programming Guide
automatically when a new measurement is initiated.
automatically when a new measurement is initiated.
This command switches on automatic
clearing of the FCO for the upper
window/upper measurement.
This command queries when the FCO is
cleared for the upper window/upper
measurement.
CALCulate Subsystem 3
175