Measure[1]|2|3|4[:Scalar][:Power:ac]:Relative? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies N1911A Programming Manual

2 MEASurement Commands
MEASure[1]|2|3|4[:SCALar][:POWer:AC]:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single
channel with relative mode on, aborts, configures then initiates the
specified channel, calculates the measurement result and places the result
on the bus. The result is a ratio based measurement and is expressed in
the units defined by UNIT[1]|2|3|4:POWer:RATio. The relative value
used is that set by the CALCulate:RELative:MAGNitude:AUTO command.
Syntax
MEAS
1
2
3
4
Parameters
Refer to
parameters in this command.
150
:SCAL :POW
expected_value
Space
DEF
"Optional Parameters"
Item Description/Default
expected_value A numeric value for the expected power level.
(for the expected The units of measurement are dBm and W. The
power level) default units are defined by UNIT:POWer.
resolution A numeric value for the resolution. If
unspecified the current resolution setting is
used.
:AC :REL
,
resolution
DEF
on page 90 for additional details on the
N1911A/1912A P-Series Power Meters Programming Guide
?
,
source list
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF