Agilent Technologies N1911A Programming Manual page 448

10 SENSe Subsystem
Example
FREQ:STEP 10
Query
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STEP?
This query is used to retrieve the number of steps in average or peak
frequency sweep.
Query Example
FREQ:STEP?
On Reset
On *RST, the value is set to 0.
Error Messages
• If no sensor or wrong sensor is connected to the channel, error –241,
• If E4410, N8480 (excluding Option CFT), E9300, E9320 or N1920 sensor
• If parameter set is lower than 0, error –222, "Data out of range; value
420
"Hardware missing" occurs.
is connected but acquisition mode is in free run, error –221, "Setting
conflict. Invalid acquisition mode" occurs.
clipped to lower limit" occurs.
This command sets frequency sweep with
10 steps for Channel A.
This query returns the number of steps in
frequency sweep for Channel A.
N1911A/1912A P-Series Power Meters Programming Guide