Fetch[1]|2|3|4[:Scalar][:Power:ac]:Ratio:relative? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies N1911A Programming Manual

FETCh[1]|2|3|4[:SCALar][:POWer:AC]:RATio:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to power
ratio with relative mode on, recalculates the measurement and places the
results on the bus. The result is a ratio based measurement and is
expressed in the units defined by UNIT[1]|2|3|4:POWer:RATio. The
relative value used is that set by the
CALCulate:RELative:MAGNitude:AUTO command.
Syntax
FETC
1
2
3
4
Parameters
Refer to
parameters in this command.
N1911A/1912A P-Series Power Meters Programming Guide
:POW
:SCAL
Space expected_value
DEF
"Optional Parameters"
Item Description/Default
expected_value The expected power level parameter can be set
(for the expected to DEF or a numeric value. If a value is entered
power level) it should correspond to that set by CONFigure
otherwise an error occurs.The units of
measurement are dBm and W. The default units
are defined by UNIT:POWer.
:RAT
:AC
,
resolution
DEF
on page 90 for additional details on the
MEASurement Commands
:REL ?
,
source list
Range of Values
sensor dependent
1
DEF
2
125