3
CALCulate Subsystem
CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>|ONCE
This command controls when the FCO (fail counter) is cleared of any limit
failures. The FCO is used to determine the results returned by the
CALCulate[1]|2|3|4:LIMit:FAIL? query.
• If ON is specified, the FCO is set to 0 each time a measurement is:
• If OFF is specified, the FCO is not cleared by the above commands.
• If ONCE is specified, the FCO is cleared only after the first initialization
Syntax
174
•
Initiated using INITiate[:IMMediate]
•
Initiated using INITiate:CONTinuous ON
•
Measured using MEASure?
•
Read using READ?
then starts accumulating any limit failures.
CALC
1
:LIM
2
3
4
:CLE
:AUTO
N1911A/1912A P-Series Power Meters Programming Guide
Space
0|OFF
1|ON
ONCE
?