[Sense[1]]|Sense2:Correction:cset[1]|Cset2[:Select] <String - Agilent Technologies N1911A Programming Manual

10 SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2[:SELect]
<string>
This command enters the name of the sensor calibration table or
frequency dependent offset table which is to be used. The CSET1 command
selects the sensor calibration table and the CSET2 command selects the
frequency dependent offset table. The calibration factor is interpolated
from the table using the setting for [SENSe[1]]|SENSe2:FREQuency.
If [SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe is set to OFF, the
N O T E
selected sensor calibration table or frequency offset table is not being used.
Syntax
SENS 1
SENS2
Parameters
392
:
CORR
Item Description/Default
string String data representing a sensor
calibration table, or frequency
dependent offset table name.
:CSET
1
:CSET2
N1911A/1912A P-Series Power Meters Programming Guide
Space
:SEL
?
Range of Values
Any existing table name
(Existing table names
can be listed using
MEMory:CATalog:TABle?).
string