Agilent Technologies N1911A Programming Manual page 161

Parameters
Refer to
parameters in this command.
N1911A/1912A P-Series Power Meters Programming Guide
"Optional Parameters"
Item Description/Default
expected_value The expected power level parameter can be
(for the expected set to DEF or a numeric value. If a value is
power level) entered it should correspond to that set by
CONFigure otherwise an error occurs.
resolution A numeric value for the resolution. If it is
unspecified the current resolution setting is
used. If a value is entered it should
correspond to the current resolution setting
otherwise an error occurs.
source list The channel which the command is
implemented on.
If unspecified the current window setup is
used. However, on the N1912A, if the window
shows a ratio or difference measurement, the
upper window defaults to Channel A and the
lower window to Channel B.
1
The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the
command sub-systems. The parameters must be entered in the specified order. If parameters are
omitted, they default from the right. The parameter DEFault is used as a place holder. Specifying
DEF leaves the parameter value unchanged.
2
When the measurement result is linear this parameter represents the number of significant
digits. When the measurement result is logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001
respectively.
MEASurement Commands
on page 90 for additional details on the
2
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
(@1)
(@2) (N1912A only)
133