Agilent Technologies N1911A Programming Manual page 123

<expected_value> returns the expected value sent by the last CONFigure
command or +20 dBm by default. Note that when the display is showing
dual windows this value is meaningless.
The <resolution> returned is the same as the value returned by
DISPlay:WINDow:RESolution?. The format of the return is <NR1> in the
range 1 through 4.
Example
CONF2?
Reset Condition
On reset:
The command function is set to :POWer:AC.
N1911A/1912A P-Series Power Meters Programming Guide
CALCulate:MATH
(SENSe2 - SENSe2)
(SENSe2 / SENSe1)
(SENSe2 / SENSe1)
(SENSe1 / SENSe2)
(SENSe2 / SENSe1)
(SENSe1/SENSe1)
*
(SENSe2/SENSe2)
(SENSe1/SENSe1)
*
(SENSe2/SENSe2)
* N1912A only.
CALCulate:RE
Lative:
STATe
ON
*
OFF
*
OFF
*
ON
*
ON
*
OFF
OFF
ON
ON
This command queries the current
configuration of the lower window/upper
measurement.
MEASurement Commands
Function
:POW:AC:DIFF:REL
:POW:AC:RAT
:POW:AC:RAT
:POW:AC:RAT:REL
:POW:AC:RAT:REL
POW:AC:RAT
POW:AC:RAT
POW:AC:RAT:REL
POW:AC:RAT:REL
2
<source list>
(@2),(@2)
(@1),(@2)
(@2),(@1)
(@1),(@2)
(@2),(@1)
(@1),(@1)
(@2),(@2)
(@1),(@1)
(@2),(@2)
95