Agilent Technologies N1911A Programming Manual page 742

15 SERVice Subsystem
Query
SERVice:SENSor[1]|2:CORRections:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the voltage to corrected power conversion.
• 1 is returned when voltage to corrected power conversion is enabled
• 0 is returned when voltage to corrected power conversion is disabled
Query Example
SERV:SENS:CORR:STAT?
Error Messages
• If INIT:CONT is not set to off, error –221, "Settings conflict" occurs.
• If the command is used when a sensor other than an E9320 power
714
sensor is connected, error –241, "Hardware missing" occurs.
This command queries whether voltage to
corrected power conversion is enabled for
Channel A.
N1911A/1912A P-Series Power Meters Programming Guide