Pstatistic[1]|2:Ccdf:table - Agilent Technologies N1911A Programming Manual

9 PSTatistic Subsystem

PSTatistic[1]|2:CCDF:TABle?

This command is used to return the data in CCDF table, average input
power, probability at the average input power, peak to average power ratio
and sample count.
This command will return 10 scalar results in the following order:
N O T E
1 Average input power (in dBm)
2 Probability at the average input power (in %)
3 Power level (power to average power ratio) that has 10 % of the power (in dB)
4 Power level (power to average power ratio) that has 1 % of the power (in dB)
5 Power level (power to average power ratio) that has 0.1 % of the power (in dB)
6 Power level (power to average power ratio) that has 0.01 % of the power (in dB)
7 Power level (power to average power ratio) that has 0.001 % of the power (in dB)
8 Power level (power to average power ratio) that has 0.0001 % of the power (in dB)
9 Peak to average power ratio (in dB)
10 Sample count
This command is only applicable when P-Series sensors are present and the following
N O T E
conditions are met:
• Free run acquisition mode is selected
• NORMal or DOUBle measurement speed setting is chosen
344 N1911A/1912A P-Series Power Meters Programming Guide