Status Register Set Commands - Agilent Technologies N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

STATus Subsystem

Status Register Set Commands

This section describes the five status register set commands. Each can be

used to examine all of the eleven status registers listed on

To apply a command to a specific register, prefix the command with the

name of the appropriate register. For example, to apply the :ENABle

command to the STATus:QUEStionable register, use the following command:

STATus:QUEStionable:ENABle

The Status Register Set commands detailed in this section are:

:NTRansition

:PTRansition

This query returns a 16 bit decimal- weighted number representing the bits

set in the Condition Register of the SCPI Register Set you require to

control. The format of the return is <NR1> in the range of 0 to 32767

Parameter Form

–1). The contents of the Condition Register remain unchanged after it

N1911A/1912A P-Series Power Meters Programming Guide

[query only]

[query only]

Show Quick Links

Table of Contents

1912a N1912a