Agilent Technologies N1911A Programming Manual page 119

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

The <resolution> parameter sets the resolution of the specified window.

This parameter does not affect the resolution of the remote data but it

does affect the auto averaging setting. Where a channel is set up in both

the upper and lower window and the <resolution> parameter settings

for these windows are different, the highest resolution setting is taken to

calculate the averaging. If you are making a ratio or difference

measurement the <resolution> parameters are applied to both channels.

The <source list> parameter is used to define:

• What channels the measurements will be made on, for a dual channel

• Whether the calculation is A- B or B- A, for a dual channel difference

• Whether the calculation is A/B or B/A, for a ratio measurement.

Entering a <source list> is only required if you are using an N1912A.

As the N1911A has a single channel only, the source list can only be

The following commands are described in this chapter:

CONFigure[1]|2|3|4?

CONFigure[1]|2|3|4

N1911A/1912A P-Series Power Meters Programming Guide

measurement.

Parameter Form

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

MEASurement Commands

[query only]

Show Quick Links

Chapters

Table of Contents

1912a N1912a