Agilent Technologies N1911A Programming Manual page 359

Query
PStatistic[1]|2:CCDF CONTinuous?
The query enters 1 or 0 into the output buffer indicating the status of the
CCDF Continuous Refresh mode.
• 1 is returned when the CCDF Continuous Refresh mode is enabled
• 0 is returned when the CCDF Continuous Refresh mode is disabled (or
Query Example
PST1:CCDF:CONT?
Error Messages
• If no sensor or wrong sensor is connected to the channel, error –241
• If channel is not in free- run acquisition mode, error –221 "Settings
N1911A/1912A P-Series Power Meters Programming Guide
CCDF Single Refresh mode is enabled)
"Hardware missing" occurs.
conflict" occurs.
This command queries whether the CCDF
Continuous Refresh mode is on or off for
Channel A.
PSTatistic Subsystem 9
331