Table 12-48 Radar: Power Meter Presets - Agilent Technologies N1911A Programming Manual

12 SYSTem Subsystem
RADAR
The following table shows the power meter presets when <character_data>
is set to RADar. Commands not listed are preset according to their
DEFault values (for further information refer to

Table 12-48 RADAR: Power Meter Presets

Command
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX]
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID
Gate Setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4
:TIME
Trigger setup
TRIG[:SEQ[1]|2]:SOUR
INIT:CONT
TRIG[:SEQ]:LEV:AUTO
TRIG[:SEQ]:LEV
TRIG[:SEQ]:SLOP
TRIG[:SEQ]:DEL
558
Setting
+10.000 GHz
NORM
E9321A/25A: DEF
E9322A/26A: DEF
E9323A/27A: OFF
N1921/2A: OFF
Gate 1: 0
Gate 2: 0
Gate 3: 750 ns
Gate 4: 0
Gate 1: 1.0 µs
Gate 2: 250 ns
Gate 3: 250 ns
Gate 4: 0
INT1
ON
ON
AUTO
POS
0 s
N1911A/1912A P-Series Power Meters Programming Guide
Table 12- 26).
Comments
Frequency setting
Measurement mode
Sensor video bandwidth
Delay between trigger point and time
gated period.
Length of time gated period for time
gated measurements.
Trigger source set up and acquisition
mode continuous triggering
Disable automatic setting of the trigger
level
Automatic Power level
Trigger event recognized on the rising
edge of a signal
Delay between recognition of trigger
event and start of a measurement