7
MEMory Subsystem
Query Example
MEM:TABL:GAIN?
Error Messages
• If more than 81 calibration factors for sensor calibration tables, or 80
• If a table is not specified using the MEMory:TABLe:SELect command,
• If any of the calibration/offset factors are outside of the allowed range,
286
offsets for frequency dependent offset tables are in the list, error –108,
"Parameter not allowed" occurs.
the data cannot be entered and error –221, "Settings conflict" occurs.
error –222, "Data out of range" occurs.
This command queries the calibration
factor/offset in the current table.
N1911A/1912A P-Series Power Meters Programming Guide