Pstatistic[1]|2:Ccdf:continuous <Boolean - Agilent Technologies N1911A Programming Manual

9 PSTatistic Subsystem
PSTatistic[1]|2:CCDF:CONTinuous <boolean>
This command is used to turn on or off the CCDF Continuous Refresh
mode for Channel A or Channel B.
This command is only applicable when P-Series sensor is present and free-run acquisition
N O T E
mode is selected. If P-Series sensor is used by the adjacent channel in a dual channel
setup, the same setting will be applied for free-run acquisition mode.
Syntax
Example
PST1:CCDF:CONT ON
PST2:CCDF:CONT OFF
Reset Condition
On reset, the CCDF Continuous Refresh mode will be turned on.
330
:CCDF
1
PST
2
:CONT
This command turns on the CCDF
Continuous Refresh mode for Channel A.
This command turns off the CCDF
Continuous Refresh mode for Channel B
and the Single Refresh mode is on.
N1911A/1912A P-Series Power Meters Programming Guide
Space
0|OFF
1|ON
?