Measure[1]|2|3|4[:Scalar][:Power:ac]:Ratio? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies N1911A Programming Manual

2 MEASurement Commands
MEASure[1]|2|3|4[:SCALar][:POWer:AC]:RATio?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to ratio
mode with relative mode off, aborts, configures then initiates both
Channel A and B, calculates the ratio measurement result and places the
result on the bus. The result is a ratio based measurement and is
expressed in the units defined by UNIT[1]|2|3|4:POWer:RATio.
Syntax
MEAS
1
2
3
4
Parameters
Refer to
parameters in this command.
156
:POW
:SCAL
expected_value
Space
DEF
"Optional Parameters"
Item Description/Default
expected_value The power meter ignores the numeric value
(for the expected entered in this parameter. Any value entered
power level) is treated like DEF.
resolution A numeric value for the resolution. If
unspecified the current resolution setting is
used.
:AC :RAT
,
resolution
DEF
on page 90 for additional details on the
N1911A/1912A P-Series Power Meters Programming Guide
?
,
source list
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF