Memory:catalog[:All] - Agilent Technologies N1911A Programming Manual

MEMory:CATalog[:ALL]?

This command lists stored sensor calibration tables (8480 Series sensors
and N8480 Series Sensors with Option CFT only), frequency dependent
offset tables and save/recall registers.
The power meter returns the data in the form of two numeric parameters
and as many strings as there are stored tables and save/recall registers:
<numeric_value>,<numeric_value>{,<string>}
• The first numeric parameter indicates the amount of memory, in bytes,
• The second numeric parameter indicates the memory, in bytes,
• Each string parameter returned indicates the name, type and size of a
A sample of a response may look like the following:
1178,26230,"DEFAULT,TABL,14","8481A,TABL,116",
"8482A,TABL,74",..........."State0,STAT,1619",
"State1,STAT,1619","State2,STAT,1619" ...........
The power meter is shipped with a set of predefined sensor calibration
tables. The data in these sensor calibration tables is based on statistical
averages for a range of Agilent Technologies power sensors. These tables
can be edited. The predefined data is listed in your user's guide. These
power sensors and table numbers are listed in
Predefined sensor calibration table is not applicable for N8480 Series power sensors with
N O T E
Option CFT. Therefore you are required to create a new sensor calibration table for the
sensors when a sensor calibration table is needed.
N1911A/1912A P-Series Power Meters Programming Guide
used for the storage of tables and registers.
available for the storage of tables and registers.
stored table or save/recall register:
• <string>, <type>, <size>
• <string> indicates the name of the table or save/recall register.
• <type> indicates TABL for sensor calibration and frequency
dependent offset tables, or STAT for a save/recall register.
• <size> indicates the size of the table or save/recall register in bytes.
MEMory Subsystem
Table 7- 19.
7
259