Agilent Technologies N1911A Programming Manual page 467

Example
SENS2:SWE3:OFFS:TIME 0.001 This command sets the delay to 0.001
Reset Condition
On reset, the value is set to 0 seconds.
Query
SENSe[1]]|SENSe2:SWEep[1]|2|3|4:OFFSet:TIME?
The query returns the current delay between the trigger point and the
start of the time- gated period.
Query Example
SENS2:SWE2:OFFS:TIME?
Error Messages
If the command is used when a sensor other than a P- Series or E9320
power sensor is connected, error –241, "Hardware missing" occurs
If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, "Settings
Conflict" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
seconds.
The query returns the current delay
between the trigger point and the start of
the time- gated period for Channel B and
gate 2.
SENSe Subsystem 10
439