Table 3-14 Measurement Units; Calculate[1]|2|3|4:Limit:upper[:Data] <Numeric_Value - Agilent Technologies N1911A Programming Manual

CALCulate[1]|2|3|4:LIMit:UPPer[:DATA] <numeric_value>
This command enters a value for the upper test limit for the specified
window/measurement used in the CALCulate[1]|2|3|4:LIMit
:FAIL? test. The units used are dependent on the current setting of
UNIT:POWer and CALCulate:RELative:STATe as shown in
When the measured power is greater than the value specified in
CALCulate[1]|2|3|4:LIMit:UPPer[:DATA],
CALCulate[1]|2|3|4:LIMit:FAIL? reports a fail. When the measured
level is less than or equal to the limit, a fail is not reported.

Table 3-14 Measurement Units

Measurement Mode
Single Channel
Ratio
Difference
Syntax
CALC
N1911A/1912A P-Series Power Meters Programming Guide
Measurement Type
Avg, Pk
Pk–Avg
Avg, Pk, Pk–Avg
Avg, Pk
Pk–Avg
:UPP
:LIM
1
2
3
4
CALC:REL:STAT OFF
Linear Log
Watt dBm
% dB
% dB
Watt dBm
% dB
Space
:DATA
CALCulate Subsystem
Table 3-
CALC:REL:STAT ON
Linear
%
%
%
%
%
numeric_value
DEF
MIN
MAX
Space
?
3
14.
Log
dB
dB
dB
dB
dB
MIN
MAX
183