Agilent Technologies N1911A Programming Manual page 133

Example
CONF1:DIFF:REL DEF,1,(@1),
(@2)
N1911A/1912A P-Series Power Meters Programming Guide
Item Description/Default
source list This channel list specifies the channels
used to calculate the difference.
If unspecified and the current window
setup is a difference measurement then
this difference setup is used, otherwise it
defaults to Channel A-B (N1912A) or A-A
(N1911A).
1
The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the
command sub-systems. The parameters must be entered in the specified order. If parameters are
omitted, they default from the right. The parameter DEFault is used as a place holder. Specifying
DEF leaves the parameter value unchanged.
2
When the measurement result is linear this parameter represents the number of significant
digits. When the measurement result is logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001
respectively.
3
N1912A only.
MEASurement Commands
This command configures the upper
window/upper measurement to make a
difference measurement of
Channel A - Channel B with relative mode
on, using the current sensor range and a
resolution of 1 on both channels.
Range of Values
3
(@1),(@2)
3
(@2),(@1)
(@1),(@1)
3
(@2),(@2)
105
2