Agilent Technologies N1911A Programming Manual page 231

Syntax
Example
CAL1:ALL
Error Messages
• If the calibration was not carried out successfully the error –231, "Data
• If zeroing was not carried out successfully the error –231, "Data
• If there is no sensor connected, the error –241, "Hardware Missing"
N1911A/1912A P-Series Power Meters Programming Guide
CAL
1
2
Questionable; CAL ERROR" occurs. If you are using an N1912A the
error message specifies which channel failed calibration.
Questionable; ZERO ERROR" occurs. If you are using an N1912A the
error message specifies which channel failed calibration.
occurs.
:ALL
This command causes the power meter to
perform a calibration sequence on
Channel A.
CALibration Subsystem 4
203