CONFigure:POWer:AC? commands.
For most applications, automatic filter length selection
N O T E
([SENSe[1]]|SENSe2:AVERage:COUNt:AUTO ON) is the best mode of operation.
However, manual filter length selection ([SENSe[1]]|SENSe2:AVERage:COUNt
<numeric_value>) is useful in applications requiring either high resolution or fast
settling times, where signal variations rather than measurement noise need filtering, or
when approximate results are needed quickly.
Syntax
SENS
SENS2
Example
AVER:COUN:AUTO OFF
Reset Condition
On reset, automatic averaging is enabled.
Query
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO?
N1911A/1912A P-Series Power Meters Programming Guide
:
1
AVER
:COUN
:AUTO
This command disables automatic filter
length selection for Channel A.
SENSe Subsystem
Space
0|OFF
1|ON
ONCE
?
10
367