Agilent Technologies N1911A Programming Manual page 797

N8480 Series
Sensors: Calibration
Factor Block Layout
Table Size:
N1911A/1912A P-Series Power Meters Programming Guide
No. Contents
Bytes
-
1
See note
1
Corrections are applied in power for E4410 Series, E9300 Series and N8480 Series
sensors (excluding Option CFT).
2
Corrections are applied in voltage versus ADC reading for E9320 Series sensors. This
format also requires only one correction factor across all power levels.
3
The block layout shown for E9320 Series sensors exists in two separate EEPROM
locations. One location contains the calibration factor data for the average path and the
other contains the calibration factor data for the peak path. These EEPROM blocks are
accessed using the SERV:SENS:CALFactor and SERV:SENS:PCALfactor
commands respectively.
Data Data
Format Range
Calibration Factor Block Layout
Units Notes
The table size is
dependent on the
number of frequency
points.
A
A-769