[Sense[1]]|Sense2:Average2 Commands - Agilent Technologies N1911A Programming Manual

[SENSe[1]]|SENSe2:AVERage2 Commands

These commands control video averaging, which is used to improve
measurement accuracy, for the P- Series and E- Series E9320 power sensor.
They combine successive measurements to produce a new composite
result.
If the command is used when a sensor other than a P-Series or E9320 power sensor is
N O T E
connected, error –241, "Hardware missing" occurs.
If the commands in this section are used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, "Settings Conflict" occurs.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>
[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>
N1911A/1912A P-Series Power Meters Programming Guide
SENSe Subsystem 10
373