Agilent Technologies N1911A Programming Manual page 410

10 SENSe Subsystem
Example
BUFF:COUN 100
Query
[SENSe[1]]|SENSe2:BUFFer:COUNt?
This query is used to retrieve the average or peak measurement buffer
size.
Query Example
BUFF:COUN?
On Reset
On *RST, the value is set to 1.
Error Messages
• If no sensor or wrong sensor is connected to the channel, error –241,
• If E4410, N8480, E9300, E9320 or N1920 sensor is connected but
• If frequency sweep step is non- zero, error –221, "Settings conflict.
382
"Hardware missing" occurs.
acquisition mode is in free run, error –221, "Setting conflict. Invalid
acquisition mode" occurs.
Frequency sweep enabled. Buffer count overidden" occurs.
This command sets the average or peak
measurement buffer size to 100 for
Channel A.
This query returns the average or peak
measurement buffer size for Channel A.
N1911A/1912A P-Series Power Meters Programming Guide